Dog trace d-fence Guide de l'utilisateur

Naviguer en ligne ou télécharger Guide de l'utilisateur pour Soins des animaux Dog trace d-fence. Dog trace d-fence User guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 13
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
d–fence
Electronic invisible fence
Service instructions
Vue de la page 0
1 2 3 4 5 6 ... 12 13

Résumé du contenu

Page 1 - Service instructions

d–fenceElectronic invisible fenceService instructions

Page 2 - Contents

10Before replacing the electrodes, make sure that you have correctly turned off the collar (remove the battery from it).If you have a longwooled dog,

Page 3 - Optional accessories

11We are starting to use the collarThe initial period of use can start when the young dog is at the age of 6 months after its elementary training is fi

Page 4

12Basic requirements● Never lay the antenna wire close to electric and telephone cables, television or satellite antenna leads. If you are unable t

Page 5 - System installation

131. This warranty is only valid when the Certifi cate of Warranty and your purchase document are submitted.2. This warranty does not apply to the fo

Page 6 - Antenna wire

2Thank you for purchasing the product DOGtrace™ d–fence from VNT electronics s.r.o., Czech Republic. We would like to ask you for reading this manual

Page 7 - Turning ON/OFF

3PrefaceDo you have a wandering pet not paying attention to your protests who likes traveling nearby and far from your house? Or is it a garden lover

Page 8

4● The unit in the emergency mode is waiting for the dog coming to the prohibited zone border (formed by an insulated wire as an antenna), divided

Page 9

5Transmitter● The transmitter must be located in a safe place protected against water and moisture. It withstands temperature variations (within tec

Page 10 - Replacement of electrodes

6Antenna wireTo make the system work, the wire must be connected to the transmitter and it must form an uninterrupted wire loop of 1 mm2 to 2,5 mm2 cr

Page 11 - Tips and information

7Turning ON● Transmitter Plug the adapter connector in the socket on the back of the transmitter unit and plug in the power outlet. You can power

Page 12 - Troubleshooting

8With your transmitter you can extend and reduce the width of the warning and correcting zones, depending on conditions in your piece of land and upon

Page 13 - Characteristics

9Correction pulse intensity settingThere are 8 modes for setting a correction pulse level and 1 mode for testing intensity of interference signals. Yo

Commentaires sur ces manuels

Pas de commentaire